Move the dish towards the position where you’d expect to find the satellite you wish to align. Switch on by pressing key # for more than a second. The unit comes with a power adaptor and a charger for the car lighter.ĩ If the preprogrammed configuration is not good for your application, please go to the “modifying configuration” section Click me to go there directly. The batteries are Li+, so not only battery life is longer but also the charging time is quite short. Therefore the SATHUNTER comes with a replaceable F/F adapter.Ĩ Li+ batteries Before starting operation make sure batteries are charged and eventually charge them for a few hours using the AL-101B power charger supplied. The input connector is a frequent point of breakdown in field instruments. Set only one point to avoid any possibility of error. Set for testing the 4 polarities on up to 4 satelites. This is a solution to make the installation and measurements with minimum operation complexity. Each set of transponder data (frequency, FEC.) will become a test point in the SATHUNTER which you can label, so you identify it easily. SATHUNTER needs to be programmed before use with transponder information from the satellites you want to work with. Check if the satellites / transponders preprogrammed in the SATHUNTER are good for your application. Drives the LNB with voltage and 22 kHz signal. Measures Power, MER, CBER and LBER for fine adjustment. Identifies the satellite and reads the service list of the selected transponder. If you have not got it yet, we hope it will help you to take a decision!ģ With the SATHUNTER, aligning a dish to the required satellite becomesįast and easy Anyone even with small technical knowledge can do the job.Ĥ Some hightlights Small, light, easy to use and rought. 1 SATHUNTER Satellite pointing made easy DVB-S2 DVB-SĢ If you have bought the SATHUNTER, this presentation
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |